Honda Insight (2019 year). Manual - part 9

127

uu

Indicators

u

Driver Information Interface Warning and Information Messages

In

strum

e

nt Pa

nel

Message

Condition

Explanation

●

Appears when you unlock and open the driver’s door 
while the power system is on by remote engine start.

2 Remote Engine Start with Vehicle Feedback

*

 P. 450

Models with remote engine starter

* Not available on all models

128

In

strum

e

nt Pa

nel

Gauges and Driver Information Interface

Gauges

Gauges include the speedometer, fuel gauge, POWER/CHARGE gauge, High 
Voltage battery charge level gauge, and related indicators. They are displayed when 
the power mode is in ON.

Displays your driving speed in mph (U.S.) or km/h (Canada).

Displays the amount of fuel left in the fuel tank.

■

Speedometer

■

Fuel Gauge

1

Speedometer

You can show another speed unit on the driver 
information interface (sub display) and set the 
displayed measurements to read in either mph and 
km/h.

2 POWER/CHARGE Gauge P. 130

1

Fuel Gauge

NOTICE

You should refuel when the reading approaches 

.

Running out of fuel can cause the engine to misfire, 
damaging the catalytic converter.

The actual amount of remaining fuel may differ from 
the fuel gauge reading.

E

Continued

129

uu

Gauges and Driver Information Interface

u

Gauges

In

strum

e

nt Pa

nel

Shows the remaining high voltage battery charge level.

■

High Voltage Battery Charge Level Gauge

1

High Voltage Battery Charge Level Gauge

The high voltage battery charge level may decrease 
under the following conditions:

•

When the 12-volt battery has been replaced.

•

When the 12-volt battery has been disconnected.

•

When the high voltage battery control system 
corrects its reading.

The charge level reading will be corrected 
automatically while driving.

Changes in the temperature of the high voltage 
battery can increase or decrease the battery’s 
charging capacity. If temperature changes cause the 
battery’s capacity to change, the number of 
indicators in the battery charge level gauge may also 
change, even if the amount of charge remains the 
same.

130

uu

Gauges and Driver Information Interface

u

Gauges

In

strum

e

nt Pa

nel

■

Electric motor

The degree to which the electric motor is 
being powered is displayed by the readings on 
the POWER side.

■

Battery charge in progress

The degree to which the High Voltage battery 
is being charged is displayed by the readings 
on the CHARGE side.

■

Speed Unit

Enables you to show another speed unit on 
the driver information interface and set the 
displayed measurements to read in either mph 
and km/h.

Select the Power/Charge screen.

2 Accessing contents in the main display 

P. 131

Press and hold the left selector wheel when 
you select the Power/Charge on the driver 
information interface. Each time you do this, 
the unit will change from mph to km/h or vice 
versa. After this, a confirmation screen will 
appear for a few seconds.

■

POWER/CHARGE Gauge

131

uu

Gauges and Driver Information Interface

u

Driver Information Interface

Continued

In

strum

e

nt Pa

nel

Driver Information Interface

The driver information interface shows the odometer, trip meter, outside 
temperature indicator, and other gauges.
It also displays important messages such as warnings and other helpful information.

■

Accessing contents in the main display

Press the 

 (home) button, then roll the left selector wheel to scroll to the content 

you want to see. Press the left selector wheel to see detailed information.

*1: Models with Display Audio

■

Switching the Display

1

Switching the Display

If a warning initially appears, you can - after reading 
it - press the 

 (home) button to proceed 

immediately to the content or to any other 
warning(s).

To go back to the previous screen, press the 

*1

 

(back) button.

To go back to the home screen, press the 

 (home) 

button.

You can edit, add, or delete the meter contents using 
the audio/information screen.

2 Customizing the Meter P. 277

Models with Display Audio

132

uu

Gauges and Driver Information Interface

u

Driver Information Interface

In

strum

e

nt Pa

nel

 (home) Button

 P. 130

 P. 135

 P. 137

 P. 139

 P. 143

 P. 141

 P. 142

 P. 148

 P. 140

 P. 140

Left Selector 
Wheel

Roll the left 
selector wheel.

 P. 147

 P. 144

*

*

 P. 150

 P. 152

 P. 149

 P. 153

 (back) Button

*

* Not available on all models

133

uu

Gauges and Driver Information Interface

u

Driver Information Interface

Continued

In

strum

e

nt Pa

nel

■

Sub display

Press the TRIP button to change the display.

Shows the total number of miles or kilometers that your vehicle has accumulated.

■

Odometer

Odometer

Outside temperature

Trip A

Trip B

TRIP Button

TRIP

TRIP

TRIP

uu

Gauges and Driver Information Interface

u

Driver Information Interface

134

In

strum

e

nt Pa

nel

Shows the total number of miles or kilometers driven since the last reset. Meters A 
and B can be used to measure two separate trips.

■

Resetting a trip meter

To reset a trip meter, display it, then press and hold the TRIP Button. The trip meter 
is reset to 0.0.

Shows the outside temperature in Fahrenheit (U.S.) or Celsius (Canada).

■

Adjusting the outside temperature display

Adjust the temperature reading by up to ±5°F or ±3°C if the temperature reading 
seems incorrect.
Use the customized features in the driver information interface or audio/information 
screen to correct the temperature.

2 Customized Features P. 153, 366

■

Trip Meter

■

Outside Temperature

1

Trip Meter

Switch between trip meter A and trip meter B by 
pressing the TRIP Button.

1

Outside Temperature

The temperature sensor is in the front bumper.
Road heat and exhaust from another vehicle can 
affect the temperature reading when your vehicle 
speed is less than 19 mph (30 km/h).

It may take several minutes for the display to be 
updated after the temperature reading has stabilized.

135

uu

Gauges and Driver Information Interface

u

Driver Information Interface

Continued

In

strum

e

nt Pa

nel

Roll the left selector wheel to switch between trip computer A and trip computer B.

■

Range & Fuel

Left Selector Wheel

Trip Computer A

Trip Computer B

Trip Meter

Range

Average Fuel 
Economy

Instant Fuel 
Economy

Roll the left 
selector wheel.

uu

Gauges and Driver Information Interface

u

Driver Information Interface

136

In

strum

e

nt Pa

nel

■

Trip meter

Shows the total number of miles or kilometers driven since the last reset. Meters A 
and B can be used to measure two separate trips.

Resetting a trip meter
To reset the trip meter, display it, press the left selector wheel and then select Reset.

u

The trip meter is reset to 0.0.

■

Average fuel economy (Avg. Fuel)

Shows the estimated average fuel economy of each trip meter in mpg or l/100 km. 
The display is updated at set intervals. When a trip meter is reset, the average fuel 
economy is also reset.

■

Instant fuel economy

Shows the instant fuel economy as a bar graph in mpg or l/100 km.

■

Range

Shows the estimated distance you can travel on the remaining fuel. This estimated 
distance is based on the vehicle’s current fuel economy.

1

Trip meter

Switch between trip meter A and trip meter B by 
rolling the left selector wheel.

Resetting the trip meter in the Range & Fuel, the trip 
meter in the sub display resets at the same time.

1

Average fuel economy (Avg. Fuel)

You can change when the average fuel economy is 
reset.

2 Customized Features P. 153, 366

137

uu

Gauges and Driver Information Interface

u

Driver Information Interface

Continued

In

strum

e

nt Pa

nel

Roll the left selector wheel to switch between trip computer A and trip computer B.

■

Speed & Time

Trip Computer A

Trip Computer B

Trip Meter

Average Speed

Elapsed Time

Left Selector Wheel

Roll the left 
selector wheel.

uu

Gauges and Driver Information Interface

u

Driver Information Interface

138

In

strum

e

nt Pa

nel

■

Trip meter

2 Trip meter P. 136

■

Elapsed Time

Shows the time elapsed since the last time Trip A or Trip B was reset.

■

Average Speed (Avg. Speed)

Shows the average speed in mph or km/h since the last time Trip A or Trip B was 
reset.

1

Elapsed Time

You can change when to reset the elapsed time.

2 Customized Features P. 153, 366

1

Average Speed (Avg. Speed)

You can change when to reset the average speed.

2 Customized Features P. 153, 366

Continued

139

uu

Gauges and Driver Information Interface

u

Driver Information Interface

In

strum

e

nt Pa

nel

Display Audio shows you turn-by-turn 
directions to your destination.

When the navigation system is not providing 
driving guidance, an image of a compass 
appears in the driver information interface.

2 Refer to the navigation system

■

Navigation

*

1

Navigation

*

Turn-by-turn directions will be shown on the driver 
information interface only when your android phone 
is connected to Android Auto

TM

.

2 Android Auto

TM

 P. 328

You can select whether to have the turn-by-turn 
display come on or not during the route guidance.

2 Customized Features P. 153, 366

Models with Display Audio

Compass

Turn-By-Turn Driving Directions

Models with Display Audio

Models with navigation system

* Not available on all models

uu

Gauges and Driver Information Interface

u

Driver Information Interface

140

In

strum

e

nt Pa

nel

2 Driver Information Interface Warning and 

Information Messages P. 102

■

Oil Life

Shows the remaining oil life and Maintenance 
Minder

TM

.

2 Maintenance Minder

TM

 P. 555

■

Warnings

1

Warnings

If there are no Warnings, None message appears on 
the driver information interface.

(Example)

■

Maintenance

141

uu

Gauges and Driver Information Interface

u

Driver Information Interface

Continued

In

strum

e

nt Pa

nel

Shows the current phone information.

2 Bluetooth® HandsFreeLink® P. 414

■

Phone

142

uu

Gauges and Driver Information Interface

u

Driver Information Interface

In

strum

e

nt Pa

nel

Shows the current audio information.

2 Audio System Basic Operation P. 262

■

Audio