|
|
|
Content .. 2222 2223 2224 2225 ..
1. Ignition OFF, disconnect the GPS coaxial cable from the GPS antenna. 2. Ignition ON, test for 4.0-5.5 volts between the center conductor and the shield of the coaxial cable. If not within the specified range, replace the GPS antenna. 3. Ignition OFF, test for less than 5 ohms or resistance at the GPS coaxial cable center conductor from end to end. If greater than the specified range, replace the GPS coaxial cable. 4. Ignition OFF, test for infinite resistance between the center conductor and the outer conductor of the GPS coaxial cable. If less than the specified range, replace the GPS coaxial cable. 5. If all circuits test normal, replace the radio. Repair Procedures Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Global Positioning System (GPS) Antenna Replacement Control Module References for radio replacement, setup, and programming DTC B2470 Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category. DTC Descriptor DTC B2470 00 Cellular Phone Antenna Circuit Malfunction Circuit/System Description The cellular antenna is connected to the vehicle communication interface module (VCIM) with a Conditions for Running the DTC
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Cellular, Entertainment, and Navigation - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|