SsangYong Stavic / SsangYong Rodius (2005 year). Service manual - part 1

1A-1

CHANGED BY

EFFECTIVE DATE

AFFECTED VIN

GENERAL INFORMATION

M162 GSL ENG SM - 2005.7

GENERAL INFORMATION

 00

SECTION 1A

Table of Contents

DESCRIPTION AND OPERATION .................................. 1A-2

Cleanliness and care ................................................. 1A-2

On-engine service ..................................................... 1A-2

COMPONENT LOCATOR ............................................... 1A-3

Front view .................................................................. 1A-3

Side view .................................................................... 1A-4

DIAGNOSTIC INFORMATION AND PROCEDURE ....... 1A-5

Oil leak diagnosis ....................................................... 1A-5

Compression pressure test ....................................... 1A-6

Cylinder pressure leakage test ................................. 1A-8

General  diagnosis .................................................... 1A-10

SPECIFICATIONS ......................................................... 1A-15

Engine specifications ............................................... 1A-15

Performance curve .................................................. 1A-16

SPECIAL TOOLS AND EQUIPMENT ........................... 1A-17

1A-2

CHANGED BY

EFFECTIVE DATE

AFFECTED VIN

GENERAL INFORMATION

M162 GSL ENG SM - 2005.7

CLEANLINESS AND CARE

An automobile engine is a combination of many
machined, honed, polished and lapped surfaces with
tolerances that are measured in the ten-thousanths of
an inch. When any internal engine parts are serviced,
care and cleanliness are important. A liberal coating of
enigne oil should be applied to friction areas during
assembly, to protect and lubricate the surfaces on initial
operation. Proper cleaning and protection of machined
surfaces and friction areas is part of the repair
procedure. This is considered standard shop practice
even if not specifically stated.

Whenever valve train components are removed for
service, they should be kept in order. They should be
installed in the same locations, and with the same mat-
ing surfaces, as when they were removed.

Battery cables should be disconnected before any ma-
jor work is performed on the engine. Failure to discon-
nect cables may result in damage to wire harness or
other electrical parts.

ON-ENGINE SERVICE

Caution

Disconnect the negative battery cable before removing
or installing any electrical unit, or when a tool or
equipment could easily come in contact with exposed
electrical terminals. Disconnecting this cable will help
prevent personal injury and damage to the vehicle.
The ignition must also be in LOCK unless otherwise
noted.

Notice

Any time the air cleaner is removed, the intake opening
should be covered. This will protect against accidental
entrance of foreign material, which could follow the
intake passage into the cylinder and cause extensive
damage when the engine is started.

DESCRIPTION AND OPERATION