|
|
Wheels and tyres 299 Tyre repair 2 3 4 5 6 7 8 9 10 11 A sticker to be adhered to the instrument The valve insert remover
1 has a gap at the lower end for a valve insert. The valve insert can 11 . Sealing and inflating a tyre Sealing the tyre ● Unscrew the tyre valve cap and insert. Use the device 1 to remove the valve cap. Place it on a clean surface. ● Shake the tyre sealant bottle vigorously
10 . ● Screw the tyre inflation hose 3 into the tyre sealant bottle. The bottle's seal will ● Remove the filler cap 3 and screw the open end of the tube into the tyre ● With the bottle upside down, empty all of the contents into the tyre. ● Remove the bottle from the valve. ● Replace the howitzer with the device
1 onto the tyre valve. Inflating the tyre ● Screw the tyre inflation tube of the compres- sor
8 on the tyre valve. ● Check that the air evacuation screw is closed 6 . ● Start the engine and leave it running. ● Attach the connector 9 to the vehicle’s 12 volt power outlet ● Switch on the air compressor with ON/OFF switch 5 . ● Keep the air compressor running until it rea- ches a pressure of 2.0-2.5 bar (29-36 psi/ A maximum of 8 minutes . ● Disconnect the air compressor. ● If it does not reach the pressure indicated, unscrew the tyre inflator tube from the valve. ● Move the vehicle 10m so that the sealant is distributed throughout the tyre. ● Screw the compressor tyre inflator into the valve. ● Repeat the inflation process. ● If it still does not come up to pressure, the tyre is too badly damaged. Stop and seek as- ● Disconnect the air compressor. Unscrew the tyre inflation tube from the tyre valve. ● When the tyre pressure is between 2.5 and 2.0 bars, continue driving without exceeding ● Attach the sticker 2 to the instru- ment panel display, within the driver's field of ● Check the pressure again after 10 minutes . WARNING When inflating the wheel, the air compressor ● Protect hands and skin from hot parts. ● Do not place the hot flexible inflator tube or hot air compressor on flammable material. ● Allow them to cool before storing the de- vice. ● If it is not possible to inflate the tyre to at least 2.0 bars (29 psi / 200 kPa), the tyre is |