Jaguar S-Type. Service manual - part 20

85

Mirrors

R

•

Make sure that the windshield in front 
of the mirror is kept clean. The 
moisture sensor for wiper operation is 
located to the front of the mirror 
casing. Any dirt may affect the 
operation of this sensor.

Driving Position Memory

86

L

Driving Position Memory

MEMORY SETTING

This optional facility enables the position 
of the driver’s seat, steering column and 
exterior rear view mirrors to be 
memorised and recalled. Two different 
driving position profiles can be entered 
into the memory.

A key does not have to be in the ignition 
switch for seat, mirror, steering column 
adjustments, nor for memory setting.

Setting a driving position

To store a driving position in the memory:

1. Adjust the seat, steering column and 

exterior rear view mirrors to the 
desired positions.

2. Push the MEMORY button (A), and 

the red LED in the switchpack will 
illuminate for a five second period.

3. While the red LED is illuminated, push 

button 1, or 2 to memorise the 
configuration. The LED will go out and 
a chime will indicate that the setting 
procedure is complete. Additionally, if 
the ignition is on (position II), the 
message center will display a 
message that the settings have been 
saved.

By repeating these three steps and 
pressing the unused button (1 or 2), a 
further driving position can be stored in 
the memory.

To set a new driving position, adjust to the 
desired position and perform steps 2 and 
3. The previous memory will be erased 
and the new position will be set.

Recalling a memorised position from 
the door switchpack

The gear selector lever in automatic 
transmission vehicles must be in P, and 
for manual transmission vehicles the 
parkbrake must be applied.

Press and release the appropriate 
memory button (1 or 2). The seat, steering 
column and door mirrors will move 
automatically to the memorised position.

Memory recall using a key transmitter

The key transmitter will recall a memory 
position when the unlock button is 
pressed, when set as follows:

1. Adjust the seat, steering column and 

exterior rear view mirrors to the 
desired positions.

2. Press the MEMORY button: the red 

LED will illuminate for a five second 
period.

3. Press any button on the key 

transmitter and then press button 1 or 
2. Both button presses must occur 
while the red LED is illuminated.

4. Repeat for the other transmitter, 

pressing the remaining memory 
button.

To cancel key transmitter memory recall:

1. Press the MEMORY button: the red 

LED will illuminate for a five second 
period.

87

Driving Position Memory

R

2. Press any button on the key 

transmitter (except the panic button), 
then press the MEMORY button 
again. Both button presses must 
occur while the red LED is illuminated.

Driving position memory system 
operating tips
• When making adjustments to a set 

driving position, reset the new 
position in the same memory channel.

• A driving position will only be 

memorised during the five second 
period when the red memory LED is 
illuminated.

• Previous memory is erased when a 

new driving position is entered.

• Make sure that the seat has 

completed moving into the required 
memory position before shifting the 
gear selector from the P position, or in 
the case of manual transmission, 
releasing the parkbrake.

• If the seat memory does not recall 

correctly, the seat may require to be 
recalibrated. This may be due to an 
interruption in the electrical supply. To 
recalibrate the seat it should be 
powered fully forwards and 
backwards and fully upwards and 
downwards.

Luggage Compartment

88

L

Luggage Compartment

LUGGAGE TIE-DOWN LOOPS

!

WARNING:

• Locate heavy loads in the luggage 

compartment towards the front of 
the vehicle and secure them to stop 
them sliding. Loose items can be a 
hazard.

• Do not drive with the luggage 

compartment lid open, as exhaust 
fumes can be drawn into the 
passenger compartment.

Four metal loops are positioned in the 
luggage compartment for attaching 
straps to secure loads and prevent them 
from sliding over the luggage floor.

These loops are not to be used for 
securing passengers or animals, nor as 
anchorages for child restraints.

A range of Jaguar storage accessories, 
including a luggage retaining net, are 
available from your Jaguar Dealer.

It is advisable to distribute luggage weight 
evenly over the entire luggage floor area, 
particularly to prevent permanent damage 
to the seat trim when a seat has been 
folded down.

Note: A luggage compartment 
emergency release handle is located in 
the luggage compartment lid. For further 
details see page 47.