|
|
|
Fuel leak(s) Fuel tank Fuel filler cap Fuel filter Push connect fittings Fuel rail Fuel injection pump Exhaust gas recirculation (EGR) system Fuel pressure control valve (FPCV) Fuel rail pressure (FRP) sensor Fuel temperature sensor Fuel injector(s) EGR system
4 . If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
5 . If the cause is not visually evident use the Jaguar approved diagnostic system or a scan tool to retrieve the fault codes before proceeding to the DTC index, or the symptom chart if no DTCs are set. Symptom Chart Symptom
Possible source
Action
Engine cranks, but does not start
IFS switch Low/contaminated fuel Air ingress Low pressure circuit fault Fuel pump module fault Blocked fuel filter FVCV blocked/contaminated FPCV blocked/contaminated Fuel injection pump failure Crankshaft position (CKP) sensor ECM fault
Check that the inertia switch has not tripped. Check the fuel level/condition, GO to Pinpoint Test G552275p3. Check the low pressure circuit for leaks/damage, Fuel Tank and Lines - 2.7L Diesel Check the fuel pump module operation, GO to Pinpoint Test G552275p2. Check the fuel filter, GO to Pinpoint Test G552275p4. Check the FVCV and FPCV, GO to Pinpoint Test G552275p5. GO to Pinpoint Test G552275p7. Check the fuel injection pump, Fuel Injection Pump For CKP sensor cicuit tests, Electronic Engine Controls Refer to the warranty policy and procedures manual if an ECM is suspect.
|