Ford Contour (1999 year). Manual - part 16

Controls and features

62

Power door locks (if equipped)

Push to lock or unlock all doors.

Power windows (if equipped)

The windows will only operate
when the ignition is switched on.
Press the appropriate control to
operate the power windows at each
door position. All of the windows
can be controlled from the control
on the driver door. The passenger
door window and the rear windows
can be operated individually with
separate door controls on the
respective door.

One-touch-down feature 

The one-touch-down feature allows
you to completely open the driver
window by briefly pressing and
releasing the bottom of the window
switch.  To stop the window before
it opens completely, press the
switch again.

The one-touch down feature only
opens the window.  To close the
window, you must press and hold
the top of the switch.

DOOR MOUNTED CONTROLS 

U

L

LOCK

13CCfen  3/25/99  1:51 PM  Page 62

Controls and features

63

Safety switch

Move the switch to the left to
prevent passengers from operating
the windows.

Move the switch to the right to
allow passengers to operate the
windows.

CHILD  LOCK  BELOW
SECURITE ENFANTS CI-DESSOUS

´

VERROUILLEE

,

LOCKED

    WHEN LOCKED,
  DOOR WON`T
OPEN FROM INSIDE.

´

VERROULEE AINSI, LA PORTE
NE PEUT S´OUVRIR DE
L´INTERIEUR.

CHILD  LOCK  BELOW

SECURITE ENFANTS CI-DESSOUS

´

VERROUILLEE

,

LOCKED

    WHEN LOCKED,
  DOOR WON`T
OPEN FROM INSIDE.

´

VERROULEE AINSI, LA PORTE
NE PEUT S´OUVRIR DE
L´INTERIEUR.

Rear door childproof safety
locks

When the lever in the rear door
lock is pushed inwards, the door
can be opened only from the
outside of the vehicle.

13CCfen  3/25/99  1:51 PM  Page 63

Controls and features

64

PULL

Remote luggage compartment
control

Pull the control located on the left
of the driver seat to open the
luggage compartment.

FLOOR MOUNTED CONTROLS

Parking brake

For information on the parking
brake, refer to Preparing to start
the vehicle in the Starting
chapter.

13CCfen  3/25/99  1:51 PM  Page 64

Controls and features

65

Fuel pump shut-off switch

For information on the fuel pump
shut-off switch, refer to Fuel
pump shut-off switch in the
Roadside emergencies chapter.

Positive retention floor mat

Position the floor mat in the
footwell. Place the mat eyelet over
the pointed end of the retention
post from the rear and rotate
forward to install. Adjust the floor
mat position to allow proper
operation of the accelerator pedal,
brake pedal, and clutch pedal (if
equipped).

To remove, lift the floor mat just
forward of the retention post and
rotate it rearward to disengage it
from the retention post.

13CCfen  3/25/99  1:51 PM  Page 65