|
|
|
Content .. 2749 2750 2751 2752 ..
If greater than the specified range, test the signal circuit for a short to voltage. If the If less than the specified range, test the signal circuit for a short to voltage. If the 6. If all circuits test normal, replace the MSM. B2170 1. Ignition OFF, disconnect the X2, X5 harness connectors at the MSM. 2. Test for 850-300k ohms between the signal circuit terminal 2 X5 and the low reference circuit terminal 6 X2. If greater than the specified range, test the signal circuit and low reference circuit for a If less than the specified range, test for a short between the signal and low reference 3. Connect the X2, X5 harness connectors at the MSM. 4. Disconnect the harness connector at the seat cushion heater element. 5. Ignition ON, test for 4.8-5.2 volts between the temperature sensor signal circuit terminal C and ground. If greater than the specified range, test the signal circuit for a short to voltage. If the If less than the specified range, test the signal circuit for a short to voltage. If the 6. If all circuits test normal, replace the MSM. Repair Procedures Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Driver Seat and Passenger Seat Cushion Heater Replacement Control Module References for the MSM replacement, setup, and programming DTC B1935 OR B2180 Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Seat Heating and Cooling - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|