|
|
|
Content .. 2696 2697 2698 2699 ..
and ground. Vertical lumbar terminal B Horizontal lumbar terminal D If greater than the specified range, test the control circuit for a short to voltage or an 4. Connect a test lamp between affected control circuit terminals listed. Vertical lumbar terminal A to terminal B Horizontal lumbarterminal C to terminal D 5. Operate the affected switch in both directions. The test lamp should turn ON when the switch is pressed in both directions. If the test lamp remains OFF during either of the commands, test for a short to ground 6. If all circuits test normal, test or replace the lumbar support. Component Testing Seat Adjuster Switch Test 1. Ignition OFF, disconnect the harness connector at the seat adjuster switch. 2. Test for infinite resistance between each control terminal and the B+ terminal with the switch in the open position. If less than the specified value, replace the seat adjuster switch. 3. Test for less than 1 ohm between each control terminal and the B+ terminal with the switch in the closed position. If greater than the specified range, replace the seat adjuster switch. 4. Test for less than 1 ohm between each control terminal and the ground terminal with the switch in the open position. If greater than the specified range, replace the seat adjuster switch. Repair Procedures Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Power Seat Switch Replacement Front Seat Adjuster Replacement (Power) Lumbar Switch Replacement Front Seat Lumbar Support Replacement
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Power Seats - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|